Powerflex 700 Vector Control User Manual Pdf
Powerflex 700 Installation Manual
Powerflex 700 Programming Manual

Powerflex 700 power jumpers, Installation instructions

Precharge Enable signal. Consult the factory for additional guidance. ATTENTION: An Auxiliary Control Power Supply Must Not be used with any PowerFlex 700 Standard Control drive or 200/240 Volt Vector Control drive. Using the power supply with these drives causes equipment/component damage. Rockwell Automation 20B PowerFlex 700 AC Drives Vector Control (v4.001 and up) User Manual. Figure 7 - torque proving flow diagram. Rockwell Automation Equipment. The PowerFlex 700 Series B User Manual provides programming and troubleshooting information for the Vector Control drive, Frames 010.

Advertising

Publication 20B-IN021B-EN-P

The PowerFlex 700 drive contains protective MOVs and Common Mode
Capacitors referenced to ground (see below). To guard against unstable
operation and/or damage, the drive must be properly configured as shown in

Powerflex 700 Vector Control User Manual

Important: All PowerFlex 700 drives are shipped with the DC bus common

mode capacitors referenced to ground.

The information in this document supersedes the MOV and Common Mode
Capacitor material in the following:

For additional general information, refer to:

Before proceeding, ensure that all power to the drive has been removed.

Title

Publication

PowerFlex 700 Vector Control User Manual

20B-UM002C

PowerFlex 700 Standard Control User Manual

20B-UM001G

PowerFlex 700 Installation Instructions - Frames 0…6 20B-IN019A
PowerFlex 700 Installation Instructions - Frames 7…10 20B-IN014E

Title

Publication

Available Online at …

PowerFlex 700 Vector Control User Manual

20B-UM002

PowerFlex 700 Standard Control User Manual

20B-UM001

Wiring and Grounding Guidelines for PWM AC Drives

DRIVES-IN001

Guarding Against Electrostatic Damage

8000-4.5.2

ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection guide.

R/L1

S/L2

T/L3

Powerflex 700 Vector Control User Manual Pdf

DC+

DC–

MOV and AC EMI Capacitor Phase to Ground

Common Mode Capacitor to Ground

Jumper-Wire

PowerFlex 700 Power Jumpers

Installation Instructions

Advertising

Powerflex 700 Installation Manual

Popular Brands

Powerflex 700 Programming Manual

Popular manuals